LT-JJ80 cabinet door hinge comprehensive testing machine

The product description

This machine is suitable for vertical static load, horizontal static load, operating force and durability test of the cabinet door finished hinge and semi-finished hinge. Open and close the hinge repeatedly in the process of simulating the common use, and check whether the hinge is damaged or other circumstances that affect the use after a certain number of cycles.

Conform to the standard

A: Standard: QB/T 2189-2013 durability test in cup-shaped dark hinges of furniture hardware

Other optional tests are as follows:

1. Operation force (optional)

2. Vertical static load (optional)

3. Horizontal static load (optional)

B: Standard: 7.1.4 durability test of sliding door in GB/T 10357.5-2011

Technical parameters

1. Test speed: 1-15 times/min (adjustable)

2. Test station: it can be moved from left to right, suitable for the left or right door opening cabinet, and it can do finished cabinet door or single product hinge test (need tooling)

3. Test tooling: detachable, can be moved up and down, the test door meets the standard requirements (as shown below), suitable for testing cabinets of different heights (maximum sample: about 1800*1900*550mm)

4. Test Angle: servo 0-180° adjustable.

5. Driving device: high precision servo motor

6. Machine frame: high strength industrial aluminum profile 80*80mm

7. Loading weight: 1kg, 2 pieces

8. Loading: 0 ~ 500N, (can be set load stop, only for evaluation)

9. Absolute error of measured stroke: ≤±0.25m

10. Stroke control range: 0.05 ~ 99.9km scale 0.25m

11. Absolute error of measurement time: 0.1 second

12. Durability test: put a certain load on the cabinet door and hinge, and then open and close the door repeatedly, after cycle a certain number of times, check whether the hinge can meet the requirements of use.

13. Vertical static load: hang the specified load 100mm away from the farthest side of the cup blind hinge, open and close the door 10 times, each time from 45 degrees to 10 degrees away from the fully closed position, reciprocate 1 time without counting, and the maximum opening Angle is 135 degrees away from the fully closed position.

14. Horizontal static load: in the fully open position of the door, apply the specified load on the horizontal center line at 100mm away from the side of the cup hinge perpendicular to the door plane. The test is conducted for 10 times.

15. Control mode: PLC+ man-machine interface

16. Overall dimension: length 2060mm× width 1500mm× height 2600mm

17. Power source: 220V,5A

The characteristics of

1. Can be used in the installed products for testing, and all kinds of hinges firmly connected and should not produce any force affecting the test. It can also directly test the finished cabinet door.

2. The drawing length Angle of the test equipment can be adjusted according to the actual testing requirements, and the Angle can be adjusted from 0℃ to 180℃.

3. The whole machine is stable and beautiful, with no exposed moving parts, and easy to operate.